[UPDATED 2026] Read NSE5_FWF_AD-7.6 Study Guide Cover to Cover as Literally
100% Real & Accurate NSE5_FWF_AD-7.6 Questions and Answers with Free and Fast Updates
NEW QUESTION # 24
You have just authorized a newly added FortiAP device on FortiGate. It went offline for an extended time without coming back online again. What troubleshooting process must you take to bring FortiAP back online?
- A. Restart the wireless controller if it is unresponsive for the newly added FortiAP device.
- B. Check the power feed to the FortiAP device and PoE status if powered by a switch.
- C. Verify that communication between FortiAP and the wireless controller is not blocked.
- D. Access FortiAP management using HTTPs.
Answer: C
NEW QUESTION # 25
Which three IETF attributes must the RADIUS server supply for dynamic VLAN allocation to work with wireless? (Choose three.)
- A. 64 Tunnel-Type
- B. 69 Tunnel-Password
- C. 65 Tunnel-Medium-Type
- D. 66 Tunnel-Client-Endpoint
- E. 81 Tunnel-Private-Group-ID
Answer: A,C,E
NEW QUESTION # 26
What protection does WPA3 wireless encryption provide over WPA2 for securing wireless networks?
- A. WPA3 enforces only enterprise security mode
- B. WPA3 addresses the KRACK vulnerability
- C. WPA3 uses 128-bit session key size
- D. WPA3 prevents legacy and deprecated wireless protocols from being used
Answer: B
NEW QUESTION # 27
Which two statements about a VAP configured for 802.1x Local Authentication are true? (Choose two.)
- A. Authenticates users created locally or on a remote LDAP server.
- B. Can support the use of a self-sighed or publicly signed certificate for server authentication.
- C. Supports the use of PEAP EAP type only.
- D. FortiGate operates as authentication server only.
Answer: B,C
NEW QUESTION # 28
A FortiAP device is connected directly to a FortiGate interface.
What discovery method will be used to provision the FortiAP device?
- A. FortiGate discovers the FortiAP IP address from DHCP option 138.
- B. FortiGate discovers the FortiAP through the received broadcast packets.
- C. FortiAP discovers FortiGate by reviewing the vendor class value.
- D. FortiAP discovers FortiGate by connecting to FortiLAN Cloud to verify its management license.
Answer: B
Explanation:
When a FortiAP and FortiGate share the same L2 network, the AP sends out a CAPWAP
"discovery" broadcast (to 255.255.255.255) and the FortiGate listens for and replies to those broadcasts, automatically provisioning the AP without requiring DHCP option configuration.
NEW QUESTION # 29
Refer to the exhibits. The exhibits show the AP profile, the controller RF analysis output, and a diagnostic summary of the AP and neighboring APs.
The wireless network is used for multiple purposes, including corporate access, guest access, and connecting point-of-sale and IoT devices. Users connecting to the guest network located in the reception area are reporting slow performance.
Which configuration change is most likely to improve performance?
- A. Install another AP in the reception area to improve available bandwidth.
- B. Enable frequency handoff on the AP to band steer clients.
- C. Increase the transmission power of the AP radios.
- D. Reduce the number of SSIDs being broadcast by the reception AP.
Answer: D
Explanation:
Every SSID (VAP) generates its own beacon and management frames, which on a heavily- utilized 2.4 GHz channel (91 % busy) adds significant overhead and cuts into airtime for client data. By cutting back to only the SSIDs needed in the reception area (for example, Guest and perhaps one additional SSID), you'll reduce beacon traffic and free up more of that already- scarce airtime for user throughput.
NEW QUESTION # 30
Refer to the exhibit. FortiGate sends logs to FortiAnalyzer using the default settings to report security events for all wireless stations as part of the Security Fabric configuration.
Which security action will FortiGate take when it detects a compromised wireless station in the CORP_DATA SSID?
- A. FortiAnalyzer generates security reports to inform security operations to further investigate the compromised stations.
- B. FortiGate disassociates compromised stations and prevents them from connecting again.
- C. FortiAP devices broadcasting CORP_DATA wireless network place compromised stations in quarantine.
- D. CORP_DATA is in NAC mode and onboards compromised stations for a period until malicious activity stops.
Answer: C
Explanation:
By assigning the CORP_DATA SSID a NAC profile (Tunnel-NAC) with "Quarantine host" enabled, the FortiGate instructs the FortiAPs to immediately isolate any client flagged as compromised, placing it into the quarantine segment (where only remediation services are reachable) even though it remains associated to the SSID. This ensures all remediation and blocking is enforced in real time at the AP.
NEW QUESTION # 31
Refer to the exhibit. Why is Radio 3 used for the spectrum analysis?
- A. The 5 GHz frequency band is available only on Radio 3.
- B. Radio 1 and Radio 2 are unavailable to run the spectrum analysis.
- C. Only Radio 3 is compatible with the selected band.
- D. Radio 3 is the configured dedicated monitoring radio for this FortiAP model.
Answer: D
NEW QUESTION # 32
A company requires a secure wireless network to span several adjacent buildings. Employees need seamless roaming access across buildings, floors, and, potentially, outdoor areas. FortiAP devices will be used.
Which deployment is the most scalable, manageable, and cost-effective in this scenario?
- A. Configure FortiGuard-capable FortiAP devices to broadcast the corporate SSID without being managed by FortiGate in the main building.
- B. Implement a wireless mesh design to allow FortiAP devices to use neighboring FortiAP devices to connect with FortiGate in the main building.
- C. Deploy a WAN connection on each building to allow FortiAP devices to communicate with FortiGate in the main building.
- D. Install FortiWiFi with a cellular modem in the buildings and areas where no wireless signal reaches from the main building.
Answer: B
NEW QUESTION # 33
Refer to the exhibit of a wireless client performance monitor.
Which performance metric is abnormal for this wireless client?
- A. The wireless client has been experiencing high background noise within the last 5 minutes.
- B. The wireless client has been transmitting traffic with all performance metrics within the normal levels.
- C. The wireless client has been dropping half of the packets transmitted within the last 5 minutes.
- D. The wireless client has been switching between available wireless bands within the last 5 minutes.
Answer: C
Explanation:
A transmission retry rate of around 25 % (one retry in four) is far above normal - indicating roughly that a quarter of all frames must be resent (and many of those may ultimately be dropped), which is an abnormal performance metric for a healthy client connection.
NEW QUESTION # 34
Which two threats on wireless networks are detected by WIDS? (Choose two.)
- A. WPA2 authentication vulnerabilities
- B. Brute-force dictionary attacks
- C. Unauthorized wireless connection
- D. Rogue access points
Answer: B,D
Explanation:
Brute-force dictionary attacks (Asleap)
WIDS includes detection for Asleap attacks - tools that perform brute-force dictionary attacks against LEAP authentication - so you'll see an intrusion alert whenever such a dictionary attack is observed on your air-side traffic Rogue access points WIDS continuously scans for and flags any unauthorized (rogue) APs broadcasting within your RF environment, alerting you the moment a rogue SSID or BSSID appears.
NEW QUESTION # 35
Refer to the exhibit. What does the red line represent?
- A. The total length of the wireless signal wavelength.
- B. A pool of channels for the wireless radio to broadcast the wireless signal.
- C. Practical channel bonding to increase high throughput.
- D. The range of channels used to allocate available airtime while transmitting data.
Answer: C
Explanation:
The red outline shows a single, wide bonded channel composed of adjacent 20 MHz channels (in this case three contiguous channels), which is how 802.11n/ac combines multiple 20 MHz slices into a wider channel to boost data rates.
NEW QUESTION # 36
Which modulation scheme offers extremely high throughput (EHT) in 802.11be technology?
- A. Orthogonal frequency division multiplexing
- B. Quadrature amplitude modulation
- C. Direct sequence spread spectrum
- D. Binary phase-shift keying
Answer: B
NEW QUESTION # 37
Which security solution can you implement in the Security Fabric to identify and prevent threats?
- A. Endpoint detection and response
- B. Integrated wireless network access
- C. Compromised wireless client quarantine
- D. Indicator of attack system
Answer: A
Explanation:
Deploying FortiEDR within the Security Fabric lets you continuously monitor endpoints for malicious behavior, automatically block or remediate attacks in real time, and share threat intelligence across your Fabric.
NEW QUESTION # 38
Refer to the exhibit. An administrator authorizes two FortiAP devices connected to this wireless controller. However, one FortiAP is not able to broadcast the SSIDs.
What must the administrator do to fix the issue?
- A. Assign the FAP231F FortiAP profile to the problematic FortiAP device.
- B. Disable the override setting on the FortiAP that is preventing it from broadcasting SSIDs.
- C. Replace the FortiAP device model to match the other device.
- D. Enable the radios on the FAP23JF FortiAP profile.
Answer: D
Explanation:
On the problem AP you can see "Channel 0" and all three SSID slots show "N/A," which means its radios are turned off in its FortiAP profile. Simply edit the FAP23JF profile, enable the 2.4 GHz/5 GHz radios and assign the SSIDs (or inherit the global SSIDs), and the AP will begin broadcasting normally.
NEW QUESTION # 39
An IT department must provide wireless security to employees connected over remote FortiAP devices who must access corporate resources at the main office.
Which action must the IT department take to enforce security policies for all wireless stations accessing corporate resources across all remote locations?
- A. Transfer local resources from corporate data centers to cloud services to offer access to remote users.
- B. Implement a teleworker topology to split traffic for further security inspection.
- C. Deploy further onsite IT personnel to these remote sites to enforce security inspection.
- D. Configure VPN tunnels to transport secured data between the main office and branch offices.
Answer: B
Explanation:
By using the teleworker mode on remote FortiAPs, all wireless client traffic is tunneled back to the central FortiGate, where security policies and inspections are uniformly applied before granting access to corporate resources.
NEW QUESTION # 40
......
Reliable Study Materials for NSE5_FWF_AD-7.6 Exam Success For Sure: https://www.prep4pass.com/NSE5_FWF_AD-7.6_exam-braindumps.html
Get Unlimited Access to NSE5_FWF_AD-7.6 Certification Exam Cert Guide: https://drive.google.com/open?id=1BE3dTs92kwwI_GT9PB84pbQFd4Do6z27
