Pass Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP) Exam in First Attempt Guaranteed Updated Dump from Prep4pass! [Q32-Q49]

Share

Pass Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP) Exam in First Attempt Guaranteed Updated Dump from Prep4pass!

Pass JN0-362 Exam with 67 Questions - Verified By Prep4pass

NEW QUESTION 32
Click the Exhibit button.

Referring to the exhibit, which statement is correct?

  • A. Routes from 10.1.1.1 are less preferred than the default local preference
  • B. Routes from 10.1.1.1 are less preferred than routes from 10.2.2.2
  • C. Routes from 10.3.3.3 are less preferred than the default local preference
  • D. Routes from 10.2.2.2 are less preferred than routes from 10.1.1.1

Answer: D

 

NEW QUESTION 33
To prevent fragmentation issues across a GRE tunnel, which MTU value is recommended for the tunnel to accommodate most IP packets?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: C

 

NEW QUESTION 34
Which statement is true about routing instances on Junos devices?

  • A. Junos device support only one routing instance.
  • B. Each routing instance is a unique grouping of routing tables, interfaces, and routing protocol parameters.
  • C. Each routing protocol runs in a separate routing instance.
  • D. Routing information cannot be shared between routing instance.

Answer: B

 

NEW QUESTION 35
Which two routing protocols make use of a designated router, or pseudo node, to represent a broadcast network? (Choose two.)

  • A. MPLS
  • B. IS-IS
  • C. OSPF
  • D. BGP

Answer: B,C

 

NEW QUESTION 36
Which IPv6 extension header notifies intermediary devices that they must inspect the packet's options?

  • A. routing header
  • B. hop-by-hop options header
  • C. fragment header
  • D. destination options header

Answer: A

 

NEW QUESTION 37
Click the Exhibit.


You have just configured a GRE tunnel, but you notice that the GRE tunnel is flapping.
Referring to the exhibit, which two would you take to solve this problem? (Choose two.)

  • A. Remove the existing 192.168.2.0/30 static route.
  • B. Add a specific route to the remote device's loopback address with the next-hop device defined as the next-hop gateway.
  • C. Add a specific static route to the local peer's network with the remote devices'loopback address as the next-hop gateway.
  • D. Set the GRE interface with a larger TTL value.

Answer: A,B

 

NEW QUESTION 38
Click the Exhibit button. An interface is configured as shown in the exhibit.
What must also be configured for this interface to participate in VLAN 100 and 200?

  • A. VLANs
  • B. encapsulation type
  • C. bridge domains
  • D. broadcast domains

Answer: C

 

NEW QUESTION 39
Click the Exhibit.

The router with the configuration shown in the exhibit has two interfaces, both of which are operational and can pass traffic. These interfaces are connected to two different routers, both of which are configured for OSPF area 0.0.0.1. The router has received LSAs and can now send traffic into the backbone area.
Which two statements are correct? (Choose two.)

  • A. The router has two OSPF adjacencies.
  • B. The router is an ASBR.
  • C. The router has only a single OSPF adjacency.
  • D. The router is an ABR.

Answer: C,D

 

NEW QUESTION 40
You notice that a route from internal BGP peer 192.168.1.1 is missing from the local route table.Which two commands would be used to help identify the source of the problem? (Choose two.)

  • A. show route receive-protocol bgp 192.168.1.1
  • B. show route bgp
  • C. show route protocol bgp hidden
  • D. show route advertising-protocol bgp 192.168.1.1

Answer: A,C

 

NEW QUESTION 41
Which two Layer 2 protocols are supported on MX Series devices? (Choose two.)

  • A. MSTP
  • B. RSTP
  • C. RIP
  • D. BGP

Answer: A,B

 

NEW QUESTION 42
Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

  • A. The router will install the 0.0.0.0/0 route into the routing table when any BGP prefixes are present
  • B. The router will install the 0.0.0.0/0 route into the routing table when no BGP prefixes are present
  • C. The router will remove the 0.0.0.0/0 route from the routing table when any BGP prefixes are present
  • D. The router will remove the 0.0.0.0/0 route from the routing table when no BGP prefixes are present

Answer: A,D

 

NEW QUESTION 43
Click the exhibit.

In the exhibit, which two routers will perform a swap action on LSP1? (Choose two.)

  • A. R3
  • B. R2
  • C. R4
  • D. R1

Answer: B,D

 

NEW QUESTION 44
Which two IP addresses are considered Martian addresses? (Choose two.)

  • A. 0.0.0.0/8
  • B. 240.0.0.0/4
  • C. 169.254.0.0/16
  • D. 192.168.0.0/8

Answer: A,B

Explanation:
Explanation/Reference: https://www.juniper.net/documentation/en_US/junos/topics/topic-map/recognize-martian-addr- routing.html

 

NEW QUESTION 45
Which two statements describe operations performed by the encapsulating tunnel endpoint in an IP-IP tunnel? (Choose two.)

  • A. It creates and adds a new inner IP header with the remote destination device's IP address
  • B. It modifies the source and destination addresses in the inner IP header
  • C. It adds an outer IP header with the destination address of the remote tunnel endpoint
  • D. It decrements the time-to-live (TTL) counter by one in the inner IP header

Answer: C,D

 

NEW QUESTION 46
Click the Exhibit button. Given the OSPF topology shown in the exhibit, how many unique link-state databases are present in the network?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: D

 

NEW QUESTION 47
Which two statements correctly describe the BGP community attribute? (Choose two.)

  • A. Only one community can be associated with a route.
  • B. The community attributes is an optional transitive attribute.
  • C. The community attribute is an optional nontransitive attribute.
  • D. Multiple communities can be associated with a route.

Answer: B,D

 

NEW QUESTION 48
Click the Exhibit button.

Referring to the exhibit, the GRE tunnel between R-1 and R-2 allows connectivity between User-1 and Server-1. When User-1 communicates with Server-2 with packets that are 1472 bytes in size, no packet fragmentation occurs. User-1 can communicate with Server-1 with packets that are up to 1448 bytes in size with no packet fragmentation. However, if the packet size is larger than 1448 bytes, packet fragmentation occurs.
Why is the packet fragmentation occurring between User-1 and Server-1 in this scenario?

  • A. The GRE header adds 20 bytes to the packet
  • B. The GRE header adds 24 bytes to the packet
  • C. The IP header adds 24 bytes to the packet
  • D. The IP header adds 20 bytes to the packet

Answer: B

 

NEW QUESTION 49
......

Penetration testers simulate JN0-362 exam: https://www.prep4pass.com/JN0-362_exam-braindumps.html

Free Test Engine For Service Provider Routing and Switching, Specialist (JNCIS-SP) Certification Exams: https://drive.google.com/open?id=1ktZV4j8x2jQW6Up1pBiYqXtlp-sO2cPG